- 15 -
2-5. Chassis Removal and Refitting
To remove lift the main bracket rear slightly and slide the
chassis away from the beznet. Ensure that the interconnecting
leads are released from their purse locks to prevent damage
being caused.
When refitting the chassis ensure that the main bracket is
located in the beznet guide slots before sliding the chassis
forwards. Refit the interconnecting leads in their respective
purse locks.
2-6. Service Position
Using the slot on the rear left of the beznet position the
chassis as indicated to access the solder side. To gain access
to the underside of the boards follow the instructions on
page 18. [Removal and Replacement of the main bracket
bottom plates ].
2-7. D and G Board Removal
To remove the G Board release the clips circled and ease the
board gently away from the support bracket. Removal of the
D Board follows the same procedure.
Clips
Slot
Summary of Contents for KD-32NX100AEP
