58
The picture is too bright.
• Using the menu system, select the “Picture Adjustment” menu and
select “Picture Mode” Then select the desired picture mode (page
22).
• Make sure that the aerial is connected using the supplied coaxial
cable.
Picture (stripe) noise.
• Keep the aerial cable away from other connecting cords.
• Do not use 300-ohm twin lead cables as interference may occur.
Poor picture (white saturation) when
viewing a signal from Scart connector
3/
.
• Make sure that the output signal of the equipment connected to the
Scart connector
3/
is not an RGB signal. If it is an RGB
signal, please connect the equipment to Scart
1/
or
2/
.
Stripe noise during playback/recording
of a VCR.
• Video head interference. Keep your VCR away from the TV.
• Leave a space of 30 cm between your VCR and the TV set to avoid
noise.
• Avoid installing your VCR in front or at the side of the TV set.
Poor or no picture (screen is dark), but
good sound.
• Using the menu system, select the “Picture Adjustment” menu and
select “Reset” to return to the factory settings (page 23).
• If the
PICTURE OFF indicator lights up in blue, press
(picture off) on the remote control.
Noisy picture when viewing a TV
channel.
• Using the menu system, select the “Manual Programme Preset”
option in the “Set Up” menu and adjust Fine Tuning (AFT) to
obtain better picture reception (page 32).
• Using the menu system, set the "Noise Reduction" option in the
“Picture Adjustment” menu to reduce the noise in the picture (page
23).
Distorted picture when changing
programmes or selecting teletext.
• Turn off any equipment connected to the Scart connector on the rear
of the TV set.
In the screen appears an image retention
(afterimage).
• Using the menu system, select the “Features” menu, next select the
“Screen Saver” submenu and finally set the “All White” option to
“On” to reduce the image retention (see page 28).
The screen flickers when turning on the
TV.
• This is inherent in the Plasma Display Panel, and does not indicate
a malfunction.
No sound/Noisy sound
Good picture, no sound.
• Press the
2
+ on the remote control.
• Check that “TV Speakers” option is set to “Main” in the “Sound
Adjustment” menu (page 25).
Audio noise.
• Make sure that the aerial is connected using the supplied coaxial
cable.
• Keep the aerial cable away from other connecting cords.
• Do not use 300-ohm twin lead cables as interference may occur.
• Communication problems may occur if the infrared communication
equipment (e.g. infrared cordless headphones) is used near the TV.
Please use headphones other than infrared cordless headphones,
move the infrared transceiver away from the TV until the noise is
eliminated, or move the transmitter and receiver of the infrared
communication equipment closer together.
Problem
Possible solution
S
S
continued...
Additional Information
01GBKEP37XS1.fm Page 58 Tuesday, March 30, 2004 8:57 AM
