Installing and Connecting the LCD Projection TV
41
In
sta
lling
and
Conne
ctin
g the
LCD Pr
o
jec
tion T
V
Connecting a DVD Player with A/V Connectors
Use this hookup if:
❑
Your DVD player does not have component (Y, P
B
, P
R
) jacks.
Disconnect all power sources before making any connections.
1
Using audio cables, connect the DVD player’s Audio OUT jacks to the
LCD projection TV’s AUDIO IN jacks.
2
Using an S VIDEO cable, connect the DVD player’s S VIDEO jack to
the LCD projection TV’s S VIDEO jack.
✍
If your DVD player has video component output connectors: for best
picture quality use the connection described on page 40.
Rear of LCD projection TV
S video cable
(not supplied)
DVD player
RK-C310/C320/C330 (not supplied)
AUDIO-R (red)
AUDIO-L (white)
S VIDEO
✍
To take advantage of the Wide Screen modes, set the TV’s aspect ratio to
16:9 on your DVD player. For details, refer to the operating instructions
supplied with your DVD player.
✍
Use TV/VIDEO on the remote control to switch between the VCR, DVD
player and cable TV inputs.
✍
If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
