Using the Features
48
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to control
with the LCD projection TV’s remote control, use the following procedure
to program the remote control.
1
Turn to the list of “Manufacturer’s Codes” on page 49, and find the
three-digit code number for the manufacturer of your equipment. (If
more than one code number is listed, use the number listed first.)
2
Press
FUNCTION
repeatedly until the DVD/VCR, SAT/CABLE or
i.LINK indicator lights up.
3
Press
SAT/CABLE
for five seconds until the indicator of the selected
input flashes.
4
While the desired indicator is flashing, enter the three-digit
manufacturer’s code number.
5
Press
ENTER
.
6
To check if the code number works, aim the LCD projection TV’s
remote control at the equipment and press
POWER
that corresponds
with that equipment. If it responds, you are done. If not, try using
another code listed for that manufacturer.
Notes
❑
If more than one code number is listed, try entering them one by one
until you come to the correct code for your equipment.
❑
If you enter a new code number, the code number you previously
entered at that setting is erased.
❑
In some cases, you may not be able to operate your equipment with the
supplied remote control. In such cases, use the equipment’s own remote
control unit.
❑
Whenever you remove the batteries to replace them, the code numbers
may revert to the factory setting and must be reset.
Function
Equipment
Programmable Code
Number
DVD/VCR
Sony DVD player
751
SAT/CABLE
Sony DSS tuner
801
i.LINK
Sony DVD player (i.LINK)
901
✍
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
✍
You must do step 5 within 10 seconds of step 4, or you must redo
steps 4 through 5.
