If you purchase the optional Active 3D Glasses, choose model TDG-
BT500A.
Steps
1.
When using the Active 3D Glasses for the first time, remove the
battery’s insulation sheet.
2.
When using the Active 3D Glasses for the first time, hold the glasses
within 50 cm (1.6 ft.) of the TV, turn on the TV, then press and hold
the (Power) button/indicator on the glasses for 2 seconds.
The Active 3D Glasses turn on and registration starts (The (Power)
button/indicator blinks green and yellow). When registration is
finished, a message appears in the bottom right corner of the TV
screen for 5 seconds, and the indicator will light up in green for 3
seconds. This process is only required one time.
If registration fails, the Active 3D Glasses will turn off automatically.
In this case, repeat the above procedure.
3.
Display the content to watch in 3D on the TV screen.
4.
Put the Active 3D Glasses on.
While watching a 3D image, the (Power) indicator blinks green
every 2 seconds.
If no 3D effect is achieved, perform the following steps.
5.
Press the 3D button to display the [3D Display] screen.
(When using the Touchpad Remote Control, press the Control Bar (
), slide the touchpad to highlight the 3D button, then press the
touchpad to select.)
6.
Press the 3D button repeatedly to select the [3D Display] mode to
suit the displayed content.
(When using the Touchpad Remote Control, press the Control Bar (
), slide the touchpad to highlight the 3D button, press the
touchpad, slide the touchpad to highlight the desired [3D Display]
mode, then press the touchpad.)
63
