43
SETU
P
Set
up
S
E
TU
P
SETU
P
S
E
TU
P
SETU
P
Setting Up the Channel List
After you finish connecting the TV, you need to run the Initial Setup
feature, which automatically creates a list of available analog and
digital channels. The Initial Setup screens appear when you turn on
your TV for the first time after hooking it up.
Using Initial Setup
To run Initial Setup
1
Press
POWER
to turn on the TV.
The Initial Setup screen appears.
2
Using the remote control, move the highlight to the desired
language, then press
to select that language.
3
The next screen instructs you to connect your cable/antenna.
Check that you’ve connected your signal source correctly.
To start Auto Program, highlight
Yes
and then press
.
Auto Program automatically creates a list of receivable analog
and digital channels. Auto Program may take 50 minutes or more
to complete. A progress bar is displayed while the channel list is
being created.
The lowest numbered channel is displayed.
To run Auto Program again at a later time
❑
Use the Auto Program feature as described on page 89.
To add individual digital channels
Use the Digital Channel feature as described on page 89.
To reset the TV to factory settings
1
Press
POWER
to turn on the TV.
2
Hold down
RESET
on the remote control.
3
Press
POWER
on the TV.
4
Release
RESET
. (The TV will turn itself off, then back on.)
If you are using a
CableCARD, Auto Program is
disabled for the CABLE input.
z
AX1X_Digital.book Page 43 Wednesday, March 2, 2005 1:13 PM
