34
GB
KLV-46/40/32V400A
3-300-887-
11
(2)
Manual Programme
Preset
Before selecting “Label”/“AFT”/“Audio Filter”/“Skip”/“Colour System”/“Signal
Booster”, press PROG +/- to select the programme number with the channel. You
cannot select a programme number that is set to “Skip” (page 34).
Programme
/
TV System
/
VHF or UHF
Presets programme channels manually.
1
Select “Programme”, then press
.
2
Press
F
/
f
to select the programme number you want to manually tune
(if tuning a VCR, select channel 00), then press RETURN.
3
Press
F
/
f
to select “TV System”, then press
.
4
Press
F
/
f
to select your TV broadcast systems, then press
.
5
Press
F
/
f
to go to the frequency range indication (“VHF Low”, “VHF
High” or “UHF”), then press
.
6
Tune the channels as follows:
Press
G
/
g
to search for the next available channel. When a channel has been found,
the search will stop. To continue searching, press
G
/
g
.
Repeat the procedure above to preset other channels manually.
Label
Assigns a name of your choice, up to five letters or numbers, to the selected channel.
This name will be displayed briefly on the screen when the channel is selected.
To input characters:
1
Press
F
/
f
to select the desired letter or number (“_” for a blank space),
then press
g
.
If you input a wrong character
Press
G
/
g
to select the wrong character. Then, press
F
/
f
to select the correct
character.
2
Repeat the procedure in step 1 until the name is completed, then press
.
AFT
Allows you to fine-tune the selected programme number manually if you feel that a
slight tuning adjustment will improve the picture quality.
You can adjust the fine tuning over a range of -15 to +15. When “On” is selected, the
fine tuning is performed automatically.
Audio Filter
Improves the sound for individual channels in the case of distortion in mono
broadcasts. Sometimes a non-standard broadcast signal can cause sound distortion or
intermittent sound muting when watching mono programmes.
If you do not experience any sound distortion, we recommend that you leave this
option set to the factory setting “Off”.
• You cannot receive stereo or dual sound when “Low” or “High” is selected.
Skip
Skips unused channels when you press PROG +/- to select channels. (You can still
select a skipped channel using the number buttons.)
Colour System
Selects the colour system (“Auto”, “PAL”, “SECAM”, “NTSC3.58”, “NTSC4.43”
or “PAL60”) according to the channel.
Signal Booster (Intelligent Signal Booster)
Improves the picture quality if the TV signal is too strong or weak.
Press
F
/
f
to select either “Off” if the signal is too strong (picture distorted; picture
with lines; signal interference) or “Auto” if the signal is weak (snowy picture), then
press .
Signal Level
Displays the signal level for programme currently being watched.
red
(weak)
amber
(average)
green
(good)
