70
Model name1[KP-46WT510] Model name2[KP-51WS510] Model name3[KP-57WS510] Model name4[KP-65WS510]
[4-094-605-12]
Other Information
Programming the Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to control
with the projection TV’s remote control, use the following procedures to
program the remote control.
From the “Manufacturer’s Codes” listed on page 72, select the three-digit
code number for the manufacturer’s code for your component. If more than
one code number is listed, start with the number listed first. Use the code
number to complete the following procedure.
To program a cable box or a satellite receiver
1
Open the panel of the remote control.
2
Press
CODE SET
inside the panel.
3
Close the panel and press
SAT/CABLE (FUNCTON)
.
4
Enter the three-digit manufacturer’s code number using the
0-9
buttons.
5
Press
ENTER
.
6
To check if the code number works, aim the projection TV’s remote
control at the component and press the green
POWER
button that
corresponds with that component. If it responds, the programming is
completed. If not, try using the other codes listed for that manufacturer.
Sony
Equipment
Switch Position
on Remote Control
Programmable
Code Number
Beta, ED Beta VCRs
AV1
303
8 mm VCR
AV2
302
VHS VCR
AV3
301
DVD Player
DVD
751
✍
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
