—
14 —
KV-32XBR200/KV-36XBR200
2-5. EXTENSION CABLE
BX board
PX board
Extension cable 11 pin
3-702-564-01
Claw
Extension cable 18 pin
3-702-541-01
3-702-558-01
Connector
• ANODE-CAP REMOVAL
WARNING:
High voltage remains in the CRT even after the power
is disconnected. To avoid electrical shock, discharge CRT before
attempting to remove the anode cap. Short between anode and
coated earth ground strap of CRT.
NOTE: After removing the anode, short circuit the anode of the
picture tube and the anode cap to either the metal chassis, CRT
shieldor carbon painted on the CRT.
• REMOVAL PROCEDURES
Do not use sharp objects which may cause damage
to the surface of the anode-cap.
Do not squeeze the rubber covering too hard to avoid
damaging the anode-cap. A material fitting called a
shatter-hook terminal is built into the rubber.
Do not force turn the foot of the rubber cover. This
may cause the shatter-hook terminal to protrude and
damage the rubber.
Turn up one side of the rubber cap in the direction
indicated by the arrow
.
Anode button
3
When one side of the rubber cap separates from
the anode button, the anode-cap can be removed
by turning the rubber cap and pulling it in the di-
rection of arrow
c
.
Use your thumb to pull the rubber cap firmly in
the direction indicated by arrow
b
.
• HOW TO HANDLE AN ANODE CAP
