Installing the TV
12
To set up your TV to use both a Cable Box and a direct-connect CATV cable:
1
Connect the Cable TV cable to the TV’s VHF/UHF jack.
2
Using a coaxial cable, connect the TV’s TO CONVERTER jack to
the cable box’s IN jack. The TV’s internal converter allows you to
switch between unscrambled signals coming straight into the TV
and scrambled signals coming in through the cable box,
eliminating the need for an external splitter.
3
Using a coaxial cable, connect the cable box’s OUT jack to the
TV’s AUX jack.
To switch between channels from Cable Box and channels coming directly into TV
❑
Press the
ANT
button on the TV remote control.
To use the TV remote control to switch channels on the cable box
❑
Program the remote control as necessary. (See “Programming the
Remote Control” on page 50.)
To use the cable box
❑
Have your TV tuner set to channel 3 or 4 (as appropriate) and
then use the Cable Box to change channels.
To prevent the accidental switching of TV channels
❑
When using the VCR or Cable Box, you can use the Channel Fix
feature to lock in a channel. The Channel Fix feature is under the
Channel menu. (See “Using the Channel Menu” on page 40.)
OUT
75-ohm coaxial cable (not supplied)
IN
AUX
TO CONVERTER
VHF/UHF
CATV cable (unscrambled channels)
Cable box
Signal
Rear of TV
