– 11 –
KV
-G21M2
RM-869
2-8.
PICTURE TUBE REMOVAL
2
Using a thumb press down, then pull up the rubber cap firmly in the direction indicated
by the arrow
b
.
3
When one side of the rubber cap is separated from the anode button, the anode-cap
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Do not damage the surface of anode-cap with sharp shaped objects.
2
Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
•
REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and the
anode cap to the metal chassis, CRT shield or carbon paint on the CRT.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in the direction indicated by the arrow
a
.
2
A board
4
C board
5
Deflection yoke
Cushion
6
Four screws
(Tapping screws)
1
Anode cap
3
F1 board
a
a
b
b
c
Anode button
Summary of Contents for KV-G21M2
Page 22: ... 22 KV G21M2 RM 869 MEMO ...
