14
S VIDEO
S-LINK/
CONTROL S
OUT
S-LINK/
CONTROL S
IN
VIDEO
AUDIO
L
R
R
VIDEO
L
(MONO)
IN
OUT
VIDEO 1 VIDEO 3 VIDEO 4 (DVD) SELECT
Y
P
B
P
R
AUDIO R AUDIO L VIDEO
LINE
OUT
OUT
IN
AUDIO R AUDIO L VIDEO
LINE
IN
OUT
IN
AUDIO
VHF/UHF
AUX
Disconnect all power sources before making any connections.
(Rear of projectionTV)
Indicates direction
of signal
Connecting two VCRs for tape
editing
SELECT OUT gives you the ability to use a
second VCR to record a program being
played by the primary VCR or to perform
tape editing and dubbing.
1
Connect the VCR intended for playback
using the connection instructions on page
9 of this manual.
2
Using an AUDIO/VIDEO cable, connect
AUDIO and VIDEO IN on the VCR
intended for recording to AUDIO and
VIDEO OUT of SELECT OUT on the TV’s
upper panel.
Notes:
• Do not change the input signal while
editing through SELECT OUT.
• When connecting a single VCR to the
projection TV: if VCR LINE OUT is
connected to VIDEO IN on the TV’s
upper panel, do not connect the SELECT
OUT on the TV’s upper panel to the VCR
LINE INPUT (see right). Doing so will
cause program interference and other
viewing problems.
• You can select the output signal from
SELECT OUT from the SET UP menu.
(see “SELECT OUT” on page 60)
VIDEO
AUDIO-L
AUDIO-R
(Rear of projection TV)
VCR (for recording)
1
2
VMC-810S/820S
(not supplied)
VCR
(for playback)
VMC-810S/820S (not supplied)
LINE
OUT
IN
SELECT
OUT
VIDEO IN
VCR
Installing and Connecting the Projection TV (continued)
VIDEO
AUDIO-L
AUDIO-R
