Sony LBT-GPX555, Operating Instructions Manual

model name [LBT-GPX555 / MHC-GPX888/GPX555]

[4-485-746-

11

(1)] GB

26

GB

filename[D:\NORM'S JOB\SONY HA\SO130059\LBT-
GPX555\4485746111_GB\06BAS.fm]

masterpage:Left

2

Press BLUETOOTH on the unit 
to select 

Bluetooth

 function.

“BLUETOOTH” appears in the 
display panel.

Note

If the system is connected to a 

Bluetooth

device, press BLUETOOTH to disconnect 
the 

Bluetooth

 device.

3

Hold down BLUETOOTH on the 
unit for 2 seconds or more.

“PAIRING” flashes in the display 
panel.

4

Perform the pairing procedure 
on the 

Bluetooth

 device.

For details, refer to the operating 
instructions of your 

Bluetooth

 device.

5

Select the model number of the 
unit on the display of the 

Bluetooth

 device.

For example, select 
“SONY:MHC-GPX888” (or 
LBT-GPX555/MHC-GPX555). 
If passkey is required on the 

Bluetooth

device, enter “0000”.

6

Perform the 

Bluetooth

connection on the 

Bluetooth

device.

When pairing is completed and the 

Bluetooth

 connection is established, 

Bluetooth

 device name appears in the 

display panel.
Depending on the 

Bluetooth

 device, 

connection may start automatically 
after pairing is completed.
You can check the 

Bluetooth

 device 

address by pressing DISPLAY 
repeatedly.

Notes

• You can pair up to 9 

Bluetooth

 devices. If the 

10th 

Bluetooth

 device is paired, the oldest 

paired device will be deleted.

• “Passkey” may be called “Passcode”, “PIN 

code”, “PIN number” or “Password”, etc., 
depending on the device.

• The pairing standby status of the system is 

canceled after about 5 minutes. If pairing is 
not successful, repeat from step 1.

• While connected to a 

Bluetooth

 device, this 

system cannot be detected and connection 
cannot be established from another 

Bluetooth

device which is never paired before.

• If you want to pair with another 

Bluetooth

device, repeat steps 1 to 6.

To cancel the pairing operation

Hold down BLUETOOTH on the unit for 
2 seconds or more until “BLUETOOTH” 
appears in the display panel.

You can operate a 

Bluetooth

 device by 

connecting the system and the 

Bluetooth

device using AVRCP.
Check the following before playing 
music:
– The 

Bluetooth

 function of the 

Bluetooth

device is turned on.

– Pairing has been completed.

1

Press BLUETOOTH on the unit 
to select 

Bluetooth

 function.

“BLUETOOTH” appears in the 
display panel.

2

Establish connection with the 

Bluetooth

 device.

The last connected 

Bluetooth

 device 

will be connected automatically.
Perform the 

Bluetooth

 connection 

from the 

Bluetooth

 device if the device 

is not connected.
Once the connection is established, the 

Bluetooth

 device name appears in the 

display panel.

3

Press 

N 

to start playback.

Depending on the 

Bluetooth

 device, 

– you may need to press 

N

 twice.

– you may need to start playing an 

audio source on the 

Bluetooth

device.

Playing music from a 

Bluetooth

 device