30
GB
Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution. Do not
use any type of abrasive pad, scouring powder or
solvent such as thinner, benzene or alcohol.
To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated.
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Take up any slack in the tape. Otherwise, the tape may
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use. Be
sure to clean the tape heads before you start an
important recording or after playing an old tape. Use a
separately sold dry-type or wet-type cleaning cassette.
For details, refer to the instructions of the cleaning
cassette.
Demagnetising the tape heads
Demagnetise the tape heads and the metal parts that
have contact with the tape after every 20 to 30 hours of
use with a separately sold demagnetising cassette. For
details, refer to the instructions of the demagnetising
cassette.
AUDIO POWER SPECIFICATIONS
(LBT-XGR600 USA model only)
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 6 ohm loads, both channels driven, from
120 – 10,000 Hz: rated 160 watts per channel
minimum RMS power, with no more than 10%
total harmonic distortion from 250 milliwatts to
rated output.
Amplifier section
North American model:
LBT-XGR600
Front speaker
Continuous RMS power output (reference):
175 + 175 watts (6 ohms at
1 kHz, 10% THD)
Total harmonic distortion less than 0.07% (6 ohms at
1 kHz, 80 W)
Other models:
LBT-XGR88
The following measured at AC 120, 220, 230 – 240 V
50/60 Hz
DIN power output (rated): 145 + 145 watts (6 ohms at
1 kHz, DIN)
Continuous RMS power output (reference):
180
×
2 + 180
×
2 watts
(6 ohms at 1 kHz, 10%
THD)
LBT-XGR66
The following measured at AC 120, 220, 230 – 240 V
50/60 Hz
DIN power output (rated): 220 + 220 watts (6 ohms at
1 kHz, DIN)
Continuous RMS power output (reference):
250 + 250 watts (6 ohms at
1 kHz, 10% THD)
Inputs
PHONO IN (phono jacks):
sensitivity 3 mV,
impedance 47 kilohms
MIC (phone jack):
sensitivity 1 mV,
impedance 10 kilohms
GAME INPUT AUDIO L/R (phono jacks):
sensitivity 250 mV,
impedance 47 kilohms
GAME INPUT VIDEO (phono jack):
1Vp-p, 75 ohms
Break off the
cassette tab
Specifications
