17
English
5-1-5. Setting offset value
∆
Y
•
After completing 5-1-4, press the Axis selector key for the offset value
∆
Y setting mode.
•
Number keys and
P
key are used to set and change the offset value
∆
Y.
•
If the display unit has been replaced and thus the offset value
∆
Y has been measured,
∆
Y may
be set in this procedure.
•
The offset value
∆
Y is factory set to 0.0000mm.
Example :
Input to the first axis
Operating Procedure
Example:To set the offset value
∆
Y to 10 mm.
Display
Note
•
When
∆
Y is not yet measured, refer to “5-12. Offset Zero Point.” (See page 42.)
•
Numbers that can be input vary according to the resolution.
Example:
In the case of 0.0005 mm: –999.9995 to +999.9995
In the case of 0.01 mm:
–99999.99 to +99999.99
If the resolution is made finer after a large value is input with a coarse resolution, an overflow
alarm display will result for the offset value
∆
Y.
•
The arrow indicator lights and REF flashes during number input, and when the
P
key is
pressed to confirm the number the arrow indicator goes out and REF lights.
X
1
0
P
Select the X-axis.
Press the number keys.
Press the Preset key to complete the setting.
mm
REF
mm
REF
mm
REF
Flashes
Lights up
Lights up
Lights up
