30
English
5-8. Mid-Point Calculation
When the INC mode display is selected, the distance from the center value is displayed by halving
the displayed value.
Note
In the example, the resolution is set to 0.0005 mm.
Operating procedure
If the ABS mode display is selected, change it
to the INC mode before operating.
The present value is displayed.
Select the X- axis.
Press the 1/2 key.
The INC indicator lights.
X
C
L
Move the machining table until the display reads “0”.
This position is the center.
Counting
To make the center position the datum point, operate as follows
Select the X-axis.
“0” input can be omitted.
Press the datum point setting key.
The ABS indicator lights.
X
S
Note
Caution is required, since the previously set datum point is canceled at this time.
Moreover, multiple datum points No. 1 to No. 9 also move in accordance with the
change of the datum point. (See the next section for multiple datum points.)
mm
INC
mm
INC
mm
ABS
0
mm
ABS
mm
INC
mm
INC
mm
mm
INC
INC
Display
