61
Routing
1.
Open the [Routing] tab of Dante Controller.
2.
Find the MAS-A100 unit with the matching Default Dante ID noted in “[Default
Dante ID] check” in the list of Dante devices displayed in [Dante Transmitters],
and check that it has two channels (Main and Rec).
3.
Find the Dante receiver device (e.g., digital mixer with Dante inputs, or
Dante/Analog converter) to be connected in the list of Dante devices displayed in
[Dante Receivers].
4.
Place check marks in the output/input matrix to route the Main output of the
MAS-A100 to the speech reinforcement system, and the Rec output of the
MAS-A100 to the recording system.
The following image shows an example where CH1 and CH2 of a Dante/Analog
converter are routed to the speech reinforcement system and the recording
system, respectively.
A green mark is displayed when routing is completed.
Clock check
1.
Open the [Clock Status] tab of Dante Controller.
2.
Check that only one Dante device displays “Master” in [Primary V1 Multicast].
If more than one Dante device displays “Master”, there is a problem with the clock
of the Dante network, and Dante audio cannot be transmitted correctly.
