Sony MAV-1000, Operation Manual

8 (E)

Location and Function of Parts

4

SDI OUTPUT (serial digital video/audio output)
connectors 1 to 8 (BNC type)

Output the serial digital video/audio signals.

Notes

• Video/audio signals are not output when the BKMA-

1020 input processor board is used.

• When the BKMA-1040 high-speed I/O processor

board is mounted, connector 7 is used for the
duplication port output connector (SDDI signals) and
connector 8 does not function.

5

REMOTE connectors 1 to 8 (D-sub 9-pin,
conforming to RS-422A standards)

For control of the input/output signals of the respective
ports.  Connect them to the RS-422A connectors of
editing units.

6

SBX INPUT connectors (BNC type)

Connect them to the SBX OUT connectors of the HDD
array units.  Connect the array units for video to the 1
to 5 connectors and the array unit for audio to the
AUDIO connector.

7

SDDI MONITOR connector (BNC type)

Outputs the component serial digital signal for input/
output monitoring when the BKMA-1040 is installed.
At a speed higher than the normal (1-time) speed, an
appropriate number of frames of video and audio
signals will be skipped.

8

SBX OUTPUT connectors (BNC type)

Connect them to the SBX IN connectors of the HDD
array units.  Connect the array units for video to the 1
to 5 connectors and the array unit for audio to the
AUDIO connector.

9

VS-BUS connector (BNC type)

Connect it to a device equipped with a VS-BUS
connector to control this server.

!º

STATUS OUTPUT connector (D-sub 15-pin)

Outputs various status data on the server, including
operating modes and errors.

!¡

RS-232C connector (D-sub 25-pin)

For ISR.
Connect it to the RS-232C connector of the host
computer, etc.

!™

ETHER (Ethernet) connector (10BASE-T,
RJ-45 modular jack, conforming to Ethernet
IEE802.3)

Connect it to the Ethernet connector of the host
computer.
This connector can be used to transmit the AV data
recorded on the server system to external systems.

!£

POWER indicators A to C

Light when the respective power switches on the front
panel are set to ON.

!¢

AC IN connectors A to C

Connect the optional power cords, respectively.

!∞

y

 (signal ground) terminal

For signal ground.  Connect when required.