— 2 —
TABLE OF CONTENTS
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK
!
OR DOTTED LINE WITH
MARK
!
ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
This appliance is classified as
a CLASS 1 LASER product.
The CLASS 1 LASER
PRODUCT MARKING is
located on the rear exterior.
This caution label is located inside
the unit.
The laser component in this product is
capable of emitting radiation exceeding
the limit for Class 1.
CAUTION
Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure.
1.
SERVICING NOTE
················································ 3
2.
TEST MODE
·································································· 4
3.
GENERAL
······································································ 6
4.
DISASSEMBLY
4-1.
CABINET ··········································································· 7
4-2.
BASE UNIT (BU-5BD24) ················································· 7
5.
ELECTRICAL ADJUSTMENTS
····························· 8
6.
DIAGRAMS
6-1.
CIRCUIT BOARDS LOCATION ···································· 10
6-2.
BLOCK DIAGRAM — BD SECTION — ······················ 11
6-3.
BLOCK DIAGRAM — MAIN SECTION — ················· 13
6-4.
SCHEMATIC DIAGRAM — BD SECTION — ············· 16
6-5.
PRINTED WIRING BOARD — BD SECTION — ········ 19
6-6.
PRINTED WIRING BOARD
— VIDEO SECTION — ················································· 21
6-7.
SCHEMATIC DIAGRAM
— VIDEO SECTION — ·················································· 23
6-8.
SCHEMATIC DIAGRAM
— DIAPLAY SECTION — ············································· 27
6-9.
PRINTED WIRING BOARD
— DISPLAY SECTION— ··············································· 31
6-10. PRINTED WIRING BOARD — MAIN SECTION— ··· 33
6-11. SCHEMATIC DIAGRAM — MAIN SECTION— ········· 35
6-12. IC BLOCK DIAGRAMS ················································· 38
6-13. IC PIN FUNCTION ························································· 41
7.
EXPLODED VIEWS
7-1.
CASE SECTION ······························································ 45
7-2.
CHASSIS SECTION ························································ 46
7-3.
MECHANISM DECK SECTION (CDM14M-5BD24) ··· 47
7-4.
BASE UNIT SECTION (BU-5BD24) ····························· 48
8.
ELECRICAL PARTS LIST
······································ 49
