50
Do not move or jog the recorder or disconnect
the power source while the “Data Save” or
“Toc Edit” indication is flashing in the
display.
1)
A new track mark is added at the point
where you pressed
P
, and the recording
will be marked with the new track number
when you resume recording.
2)
Once you open the lid, the point to start
recording will change to the beginning of
the first track. When recording on a
recorded MD, check the point to start
recording on the display.
If the recording does not start
Make sure the MD is not record-protected.
If the tab at the side of the MD is open,
slide it back so the tab is visible.
Note
If the power supply is disrupted (i.e. the
battery is removed or becomes exhausted or
the AC power adaptor is disconnected) when
the recorder is operating, the lid will not open
until the power is restored.
To
Pause
Record over
partway through
the previous
recording
Remove the MD
Press
P
.
1)
Press
P
again to
resume recording.
(
,
+
or
=
to
find the start point of
recording and press
p
to stop. Then slide
the REC switch.
p
, then press OPEN
and open the lid.
2)
z
MD recording
Recording an MD right away!
See the illustrations in the Japanese text
(page 10 to 11).
Use a line cable (not supplied) to hook up
an analog source. The sound will be sent
from the connected equipment as analog
signal but will be recorded digitally on the
disc. If you want to record programs from
digital equipments or a microphone, see
"Various ways of recording".
Premastered MDs cannot be recorded over.
1
Make connections (Connect securely).
1
Connect the LINE IN (OPTICAL)
jack of recorder to the LINE OUT
R(red)/L (white) jacks of the
source with a line cable.
The recorder switches to analog
input automatically.
2
Connect the DC IN 3V jack of the
recorder to a wall outlet with the
supplied AC power adaptor.
When the recorder has different sound
sources connected at the same time,
the recorder switches to the digital,
microphone, or analog input in this
order of priority.
2
Insert a recordable MD.
1
Press OPEN and open the lid.
2
Insert a recordable MD with
the label side facing up, and
press the lid down to close.
3
Select recording start point.
If you want to add a recording to the
end of the previous recording, press
END SEARCH.
(If you want to start recording from the
beginning, skip this step).
4
Start recording.
1
Press and slide the REC switch to
the right.
“REC” lights up and recording
starts .
2
Play the sound source.
The level of the recorded sound is
adjusted automatically.
To stop recording, press
p
.
