— 33 —
3-5. Functions of Other Buttons
Note : The erasing-protection tab is not detected during the test mode. Recording will start regardless of the position of the erasing-protection
tab when the
r
(REC) button is pressed.
Contents
Sets continuous playback when pressed in the STOP state. When pressed during continuous playback, the tracking servo turns ON/OFF.
Stops continuous playback.
The sled moves to the outer circumference only when this is pressed.
The sled moves to the inner circumference only when this is pressed.
Switches between the pit and groove modes when pressed.
Switches the spindle servo mode (CLVS and A).
Switches the display when pressed.Returns to previous step. Stops operations.
Function
^
p
)
0
SINGLE
A. MODE
DISPLAY
3-6. Test Mode Displays
Each time the DISPLAY button is pressed, the display changes in the following order.
MODE display
n
Error rate display
n
Address display
1. MODE display
Displays “TEMP ADJUST”, “CPLAY MODE”, etc.
2. Error rate display
Error rates are displayed as follows.
C1 =
AD =
C1 = : Indicates C1 error
AD = : Indicates ADER
3. Address display
Addresses are displayed as follows.
h =
s =
(MO pit and CD)
h =
a =
(MO groove)
h = : Header address
s = : SUBQ address
a = : ADIP address
* is displayed when the address cannot be read.
3-7. Meanings of Other Displays
During continuous playback
Tracking servo OFF
CLV LOCK
Pit
High reflection
CLV-S
ABCD adjustment completed
STOP
Tracking servo ON
CLV UNLOCK
Groove
Low reflection
CLV-A
Display
Contents
Light
Off
Blinking
^
LED
e
LED
SYNC
TRACK
DISC
SPEED
A. PAUSE
REPEAT 1
Focus auto gain successful
Tracking auto gain failed
3-8. Precautions for Use of Test Mode
1
As loading related operations will be performed regardless of the test mode operations being performed, be sure to check that the disc is
stopped before setting and removing it.
Even if the EJECT button is pressed while the disc is rotating during continuous playback, the disc will not stop rotating.
Therefore, it will be ejected while rotating.
Always press the EDIT/NO button first before pressing the EJECT button.
2
Most buttons can not be used while the error rate is displayed due to bugs of IC121 CXD2535CR.
Focus auto gain successful
Tracking auto gain failed
Summary of Contents for MDS-B6P
