– 45 –
– 46 –
• Circuit Boards Location
AC board
SW board
BAT board
MAIN board
VOL board
DISP board
BD board
PSW board
HP board
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
%
: indicates tolerance.
•
¢
: internal component.
•
C
: panel designation.
Note on Printed Wiring Boards:
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
®
: Through hole.
•
b
: Pattern from the side which enables seeing.
•
U
: B+ Line.
•
V
: B– Line.
• Voltages and waveforms are dc with respect to ground in
playback mode.
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
E
: PB
j
: REC
p
: PB (Digital out)
l
: REC (Digital in)
• Abbreviation
CND : Canadian model.
Note:
The components identi-
fied by mark
!
or dotted
line with mark
!
are criti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque
!
sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Side B)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side A)
the parts face are indicated.
• Indication of transistor.
B
These are omitted.
C
E
Q
C
B
These are omitted.
E
Q
6-4.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
• Abbreviation
CND
: Canadian model.
Summary of Contents for MDS-JB920
Page 12: ... 12 ...
Page 13: ... 13 ...