– 17 –
4-6. FUNCTIONS OF OTHER BUTTONS
¢
Contents
Sets continuous playback when pressed in the STOP state. When pressed during continuous
playback, the tracking servo turns ON/OFF.
Stops continuous playback and continuous recording.
The sled moves to the outer circumference only when this is pressed.
The sled moves to the inner circumference only when this is pressed.
Switches between the pit and groove modes when pressed.
Switches the spindle servo mode (CLV S
˜
CLV A).
Switches the displayed contents each time the button is pressed
Ejects the disc
Exits the test mode
Function
p
)
0
PLAY MODE
n
LEVEL/DISPLAY/CHAR
(
*
)
PLAY MODE
n
PLAY MODE
(
*
)
LEVEL/DISPLAY/CHAR
§
REPEAT
4-7. TEST MODE DISPLAYS
Each time the LEVEL/DISPLAY/CHAR button is pressed, the display changes in the following order.
1. Mode display
Displays “TEMP ADJUST”, “CPLAYMODE”, etc.
2. Error rate display
Displays the error rate in the following way.
C1 = AD =
C1 = Indicates the C1 error.
AD = Indicates ADER.
3. Address display
The address is displayed as follows. (MO:recordable disc, CD:playback only disc)
If the LEVEL/DISPLAY/CHAR button is pressed after pressing the
PROGRAM button, the display switches from groove to pit or vice versa.
h = s = (MO pit and CD)
h = a = (MO groove)
h = Indicates the header address.
s = Indicates the SUBQ address.
a = Indicates the ADIP address.
Note: “–” is displayed when servo is not imposed.
4. Auto gain display (Not used in servicing)
The auto gain is displayed as follows.
AG = / [ ]
5. Detrack check display (Not used in servicing)
The detrack is displayed as follows.
ADR =
6. IVR display (Not used in servicing)
The IVR is displayed as follows.
[ ][ ][
Mode display
Error rate display
Address display
Auto gain display (Not used in servicing)
Detrack check display (Not used in servicing)
IVR display (Not used in servicing)
(
*
)When displayed as “PLAY MODE
n
PLAY MODE”, it means to press the PLAY MODE button, and then press it again. When pressed
the first time, the fluorescent display tube displays “PROGRAM”.
