Rec
o
rd
ing
to M
D
s
filename[\\WIN-48\NAKAYAMA 3-1\4233926121 3.14\423392612MDSJE770U2\GB05OPE-
U2.fm]
15
model name1[MDS-JE770] model name 2 [MDS-JE470]
[4-233-926-12(1)]
masterpage:Left
(3 column)
Marking track numbers while
recording
— Manual/Automatic Track Marking
You can mark track numbers either manually or
automatically while recording. By marking
track numbers at specific points, you can
quickly locate the points later or edit the MD
easily.
Marking track numbers manually
(Manual Track Marking)
While recording, press REC
z
at the point
where you want to add a track number.
Marking track numbers automatically
(Automatic Track Marking)
When recording from a CD player or MD deck
connected to a DIGITAL IN connector, the deck
marks track numbers in the same sequence as
the source. When recording from other sources
connected to the DIGITAL IN connector or a
source connected to the ANALOG IN jacks, do
the procedure below to mark track numbers
automatically. However, you cannot mark track
numbers automatically if the sound source to be
recorded is noisy (e.g., tapes or radio
programs).
1
While the deck is stopped, press MENU/
NO.
2
Turn AMS (or press
./>
repeatedly) until “Setup?” appears,
then press AMS or YES.
3
Turn AMS (or press
./>
repeatedly) until “T.Mark LSyn(c)”
appears, then press AMS or YES.
4
Turn AMS (or press
./>
repeatedly) to select the setting, then
press AMS or YES.
5
Press MENU/NO.
When you set Automatic Track Marking to
on, “L.SYNC” lights up.
The deck marks a track number whenever
the input signal level drops to –50 dB
(the
trigger level for Automatic Track Marking)
or below for at least 1.5 seconds.
1)
Factory setting
To change the trigger level for
Automatic Track Marking
Do the procedure below to change the signal
level that triggers Automatic Track Marking.
1
While the deck is stopped, press MENU/
NO.
2
Turn AMS (or press
./>
repeatedly) until “Setup?” appears,
then press AMS or YES.
3
Turn AMS (or press
./>
repeatedly) until “LS(T)” appears, then
press AMS or YES.
4
Turn AMS (or press
./>
repeatedly) to select the level, then
press AMS or YES.
You can set the level at any value between
–72 dB and 0 dB, in 2 dB increments
(–50 dB is the factory setting).
5
Press MENU/NO.
Tips for automatic track marking
•
When recording from a CD player or an MD deck
connected to the DIGITAL IN connector, the entire
material might be recorded as a single track in the
following cases:
— When you consecutively record the same track
two or more times using single-track repeat play.
— When you consecutively record two or more
tracks with the same track number but from
different CDs or MDs.
— When you record tracks from certain CD or
multi-disc players.
•
A track number might not be marked for tracks less
than 4 seconds long (in Stereo mode, Monaural
mode, and LP2 Stereo mode) or 8 seconds long (in
LP4 Stereo mode) during recording.
•
When recording from a component connected to the
ANALOG IN jacks with “T.Mark Off” selected or
when recording from a DAT deck or DBS tuner
connected to the DIGITAL IN connector, the entire
material may be recorded as a single track.
To
Select
Turn on Automatic
Track Marking
T.Mark LSyn(c) (factory
setting)
Turn off Automatic
Track Marking
T.Mark Off
continued
