10
GB
Troubleshooting
If you experience any of the following difficulties
while using the deck, use this troubleshooting
guide to help you remedy the problem. Should
any problem persist, consult your nearest Sony
dealer.
The deck does not operate or operates
poorly.
• The MD may be dirty or damaged. Replace
the MD.
• When the MD deck is connected to a
computer and the operating system is running,
you can only use the
x
/
Z
button (for ejecting
the MD while the deck is stopped).
The deck does not play.
• Moisture has formed inside the deck. Take
the MD out and leave the deck in a warm
place for several hours until the moisture
evaporates.
• The deck may not be connected to the
amplifier correctly. Check the connection.
• The MD is inserted in the wrong direction.
Slide the MD into the disc slot with the label
side up and the arrow pointing towards the
slot.
• The MD may not be recorded. Replace the
disc with one that has been recorded.
The sound has a lot of static.
• Strong magnetism from a television or a
similar device is interfering with operations.
Move the deck away from the source of
strong magnetism.
The deck does not record.
• The MD is record-protected. Slide the record-
protect tab and close the slot.
• The deck is not connected properly to the
computer. Check the connection.
• A premastered MD is inserted. Replace it
with a recordable MD.
• There is not enough time left on the MD.
Replace it with another recordable MD with
fewer recorded tracks, or erase unnecessary
tracks.
• There has been a power failure or the AC
power adaptor has been disconnected during
recording. Data recorded to that point may be
lost. Repeat the recording procedure.
The total recorded time and the
remaining recordable time on
the MD may not total the
maximum recording time
Recording is done in minimum units of 2
seconds* each, no matter how short the material.
The contents recorded may thus be shorter than
the maximum recording capacity. Disc space may
also be further reduced by scratches.
* When recording in stereo mode. (Approx. 4 seconds
in mono or LP2 mode, and approx. 8 seconds in
LP4 mode.)
Tracks created through editing
may exhibit sound dropout as
you’re searching for a point
while monitoring the sound.
Some tracks can’t be combined
with others
Tracks may not be combined if they have been
edited.
The playback indicator flashes
for a long time
If the inserted recordable MD is brand new, the
playback indicator flashes longer than for MDs
that have already been used.
System Limitations (continued)
Summary of Contents for MDS-NT1
Page 13: ...Additional Information 13GB ...
Page 25: ...Informations additionnelles 13FR ...
Page 37: ...Información adicional 13ES ...
