21
4-5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
1
Set the disc in the unit. (Whichever recordable discs or discs for playback only are available.)
2
Rotate the AMS knob and display “CPLAY1MODE”(C34).
3
Press the
@/1
button to change the display to “CPLAY1 MID”.
4
When access completes, the display changes to “C =
AD =
)”.
Note :
The numbers “ ” displayed show you error rates and ADER.
2. Changing the parts to be played back
1
Press the
@/1
button during continuous playback to change the display as below.
When pressed another time, the parts to be played back can be moved.
2
When access completes, the display changes to “C =
AD =
)”.
Note :
The numbers “ ” displayed show you error rates and ADER.
3. Ending the continuous playback mode
1
Press the
x/Z
button. The display will change to “CPLAY1MODE”(C34).
2
Press the
x/Z
“PGM” button to remove the disc.
Note :
The playback start addresses for IN, MID, and OUT are as follows.
IN
40h cluster
MID 300h cluster
OUT 700h cluster
4-5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check.)
1. Entering the continuous recording mode
1
Set a recordable disc in the unit.
2
Rotate the AMS knob and display “CREC 1MODE” (C35).
3
Press the
@/1
button to change the display to “CREC1 MID”.
4
When access completes, the display changes to “CREC1 (
)” and
REC
lights up.
Note :
The numbers “ ” displayed shows you the recording position addresses.
2. Changing the parts to be recorded
1
When the
@/1
button is pressed during continuous recording, the display changes as below.
When pressed another time, the parts to be recorded can be changed.
REC
goes off.
2
When access completes, the display changes to “CREC1 (
)” and
REC
lights up.
Note :
The numbers “ ” displayed shows you the recording position addresses.
3. Ending the continuous recording mode
1
Press the
x/Z
button. The display changes to “CREC 1MODE” (C35 ) and
REC
goes off.
2
Press the
x/Z
“PGM” button to remove the disc.
Note 1 :
The recording start addresses for IN, MID, and OUT are as follows.
IN
40h cluster
MID
300h cluster
OUT
700h cluster
Note 2 :
The
x/Z
button can be used to stop recording anytime.
Note 3 :
Do not perform continuous recording for long periods of time above 5 minutes.
Note 4 :
During continuous recording, be careful not to apply vibration.
“CPLAY1 MID”
t
“CPLAY1 OUT”
t
“CPLAY1 IN”
“CREC1 MID”
t
“CREC1 OUT”
t
“CREC1 IN”
