25
5-6-4. Auto Check
(See page 28)
Start
YES
NO
NO
NO
NO
NO
NO
NO
NO
YES
YES
YES
YES
YES
YES
YES
Replace IC195
Replace OP or IO195
Replace IC101, IC195, or D101
5-11. Iop NV SAVE (See page 31)
Replace OP, IC190, or IC195
Replace OP, IC102, IC190,
or IC195
Replace OP, IC101, IC151,
or IC195
Replace OP
Replace the spindle motor
End adjustments
After turning off and then on the power,
initialize the EEPROM
For details, refer to 4-11. WHEN MEMORY NG IS
DISPLAYED (See page 23)
• Abbreviation
OP: optical pick-up
5-7. INITIAL SETTING OF ADJUSTMENT VALUE
(See page 30)
5-9. TEMPERATURE COMPENSATION OFFSET
ADJUSTMENT (See page 30)
5-10. LASER POWER ADJUSTMENT (See page 30)
5-12. TRAVERSE ADJUSTMENT (See page 31)
5-13. FOCUS BIAS ADJUSTMENT (See page 32)
5-16. AUTO GAIN CONTROL OUTPUT LEVEL
ADJUSTMENT (See page 33)
OP change in Err Display mode
Iop write
Spdl change in Err Display mode
Adjustment flow
