5
EN
Attaching the front panel
Align part
A
of the front panel to part
B
of
the unit as illustrated, and push until it clicks.
Notes
• Be sure not to attach the front panel upside
down.
• Do not press the front panel hard against the
unit when attaching it. Press it lightly against the
unit.
• Do not press hard or put excessive pressure on
the display window of the front panel.
• Do not expose the front panel to direct sunlight,
heat sources such as hot air ducts, and do not
leave it in a humid place. Never leave it on the
dashboard of a car parked in direct sunlight
where there may be a considerable rise in
temperature.
Caution alarm
If you turn the ignition key switch to the OFF
position without removing the front panel, the
caution alarm will beep for a few seconds
(only when the POWER SELECT switch is set
to the
A
position).
Preparing the rotary
commander
When you mount the rotary commander,
attach the label in the illustration below.
A
B
Reset button
(OFF)
(RELEASE)
Getting Started
Resetting the unit
Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Press the reset button with a pointed object,
such as a ball-point pen.
Note
Pressing the reset button will erase the clock and
some memorized functions.
Detaching the front panel
You can detach the front panel of this unit to
prevent the unit from being stolen.
1
Press
(OFF)
.
2
Press
(RELEASE)
to open up the front
panel. Then slide the font panel a little
to the left, and pull it towards you.
Notes
• Be sure not to drop the panel when detaching it
from the unit.
• If you press
(RELEASE)
to detach the panel while
the unit is still on, the unit will turn off
automatically to prevent the speakers from
being damaged.
• When you carry the front panel with you, put it
in the supplied front panel case.
SOUND
LIST
MODE
SOUND
LIST
MODE
Getting Started
Summary of Contents for MDX-62
Page 23: ...23 EN ...
Page 24: ...24 EN I 3 862 552 51 1 Sony Corporation Printed in Japan ...