MEX-DV150UE/DV1500U/DV1505U
4
NOTE FOR FLEXIBLE BOARD OF THE OPTICAL
PICK-UP
When connecting or disconnecting the
fl
exible board of the opti-
cal pick-up to or from the CN2 of the SERVO board, follow the
procedure given below.
Note:
When soldering the short lands, solder within 5 seconds at the tem-
perature of soldering iron below 300°C.
Disconnection:
1. Solder two shortland.
2. Disconnect the
fl
exible board from the CN2 of the SERVO
board.
Connection:
1. Connect
the
fl
exible board to the CN2 of the SERVO board.
2. Unsolder two shortland.
KEY board
USB (socket) connector
front panel
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension cable) as shown below.
• Connect the MAIN board (CN101) and the SERVO board (CN3) with the extension cable (Part No. J-2502-062-1).
NOTE FOR REPLACING OF THE USB CONNECTOR
(CN902)
To replace the USB connector requires alignment.
1. Insert the USB connector into the front panel.
2. Place the KEY board on the front panel and align the terminals
of the USB connector with the holes in the KEY board.
3. Solder the six terminals of the connector.