36
To hide the system setup display, press
(SYSTEM SETUP)
.
Note
For Super Audio CDs consisting of only a Super Audio
CD layer, that layer is played regardless of setting.
Tip
The setting in visual setup will switch the setting in
system setup automatically, and vice versa.
Selecting the sound quality
This unit allows you to change the sound quality
of Super Audio CD playback by switching the
sampling frequency.
The setting is configurable both from the visual
setup menu (page 43) and the system setup menu
(page 47).
The options for “SUPER AUDIO CD MODE”
(visual setup) and “SA-CD MOD” (system
setup) are indicated below.
HQ
: Outputs at 176.4 kHz (high sound quality).
STD
: Outputs at 44.1 kHz (standard CD sound
quality).
By the visual setup menu
The setting procedure is the same as for setting
the playback layer (page 35).
Press
(VISUAL SETUP)
, then select “AUDIO
SETUP”
c
“SUPER AUDIO CD MODE”
c
“HQ” or “STD.”
By the system setup menu
The setting procedure is the same as for setting
the playback layer (page 35).
Press
(SYSTEM SETUP)
, then select “SA-CD
MOD”
c
“HQ” or “STD.”
Note
When set to “HQ,” EQ7 (page 39), CSO (page 39),
Intelligent Time Alignment (page 40) and HPF/LPF
(page 50) settings are deactivated. To activate, set to
“STD.”
Tip
The setting in visual setup will switch the setting in
system setup automatically, and vice versa.
Advanced Operations — Radio
Storing and receiving stations
Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically — BTM
1
Press
(SRC)
repeatedly until “TUNER”
appears on the main unit.
To change the band, press
(MODE)
repeatedly. You can select from FM1, FM2,
FM3, MW or LW.
2
Press
(SYSTEM SETUP)
.
The system setup item appears.
3
Press
M
/
m
to select “BTM,” then press
(ENTER)
.
The unit stores stations in order of frequency
on the number buttons (
(1)
to
(6)
).
A beep sounds when the setting is stored.
With the main unit
Press
(SOURCE)
instead of
(SRC)
, rotate the volume
control dial instead of pressing
M
/
m
.
Storing manually
1
While receiving the station that you
want to store, press and hold a
number button (
(1)
to
(6)
) until
“MEM” appears on the main unit.
The number button indication appears on the
main unit.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.
Tip
When an RDS station is stored, the AF/TA setting is
also stored (page 37).
Z
X
Z
M/m
ENTER
MODE
SYSTEM
SETUP
SRC
Number
buttons