8
GB
Detaching the Front Panel
You can detach the front panel of this unit to
prevent theft.
1
Press and hold OFF
until the unit
turns off, press the front panel
release button
, then pull the panel
towards you to remove.
Caution alarm
If you turn the ignition switch to the OFF
position without detaching the front panel,
the caution alarm will sound for a few
seconds. The alarm will only sound if the
built-in amplifier is used.
Serial numbers (MEX-N5300BT only)
Make sure the serial numbers on the bottom
of the unit and the back of the front panel
are matched correctly. Otherwise you cannot
make BLUETOOTH pairing, connection and
disconnection by NFC.
Resetting the Unit
Before operating the unit for the first time,
after replacing the car battery, or changing
the connections, you must reset the unit.
1
Press DSPL and CALL for more than
2 seconds.
Note
Resetting the unit will erase the clock setting and
some stored contents.
Setting the Clock
1
Press MENU, rotate the control dial to
select [GENERAL], then press it.
2
Rotate the control dial to select [SET
CLOCK], then press it.
3
Rotate the control dial to select
[MANUAL], then press it.
The hour indication flashes.
4
Rotate the control dial to set the hour
and minute.
To move the digital indication, press
/
(SEEK –/+).
5
After setting the minute, press MENU.
The setup is complete and the clock
starts.
To display the clock
Press DSPL.
To set the clock automatically
Select [AUTO <RDS>] in step 3.
Checking the Battery
Voltage
You can check the current battery voltage.
(Not available while the source is off and the
clock is displayed.)
1
Press DSPL repeatedly until the
battery voltage display appears.
Getting Started
Attaching the front panel
