36
GB
Notes on installing the connection cable RC-SR1 (not
supplied)
Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
Depending on the type of car, be sure to insulate the
unused leads with electrical tape for safety.
Do not connect this cable when the steering wheel
remote control is not used.
Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STR
CONTROL] in [SET STEERING] to [EXTERNAL]
(page 19).
Installation
Before installing the unit, remove the protection
collar
and the bracket
from the unit.
1
Pinch both edges of the protection collar
, then pull it out.
2
Insert both release keys
until they
click, and pull down the bracket
, then
pull up the unit to separate.
Note for MEX-N4100BT
Before installing this unit, remove the screw and box on
the back of the unit. Do not use the previous parts you
removed when installing the unit.
Before installing, make sure the catches on both
sides of the bracket
are bent inwards 2 mm (
3
/
32
in). When mounting in a Japanese car, see
“Mounting the unit in a Japanese car” (page 37).
1
Position the bracket
inside the
dashboard, then bend the claws outward
for a tight fit.
2
Mount the unit onto the bracket
, then
attach the protection collar
.
Notes
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
Make sure the 4 catches on the protection collar
are properly engaged in the slots of the unit.
Removing the protection collar and the
bracket
Face the hook inwards.
Mounting the unit in the dashboard
Screw
Box
182 mm (7
1
/
4
in)
53 mm (2
1
/
8
in)
Catch
