F:\#Work#\0830\4597143611\4597143611MEXN5200BTUC\01GB-
MEXN5200BTUC\040CD.fm
masterpage: Right
MEX-N5200BT
4-597-143-
61
(1)
33
GB
Pairing failed due to a timeout.
q
Depending on the connecting device, the
time limit for pairing may be short.
– Try completing the pairing within the
time.
BLUETOOTH function cannot operate.
q
Turn off the unit by pressing OFF for more
than 2 seconds, then turn the unit on
again.
No sound is output from the car speakers
during handsfree call.
q
If the sound is output from the cellular
phone, set the cellular phone to output
the sound from the car speakers.
Siri Eyes Free is not activated.
q
Perform the handsfree registration for an
iPhone that supports Siri Eyes Free.
q
Set the Siri function on the iPhone to on.
q
Cancel the BLUETOOTH connection with
the iPhone and the unit, and reconnect.
SongPal operation
Application name is mismatched with the
actual application in “SongPal”.
q
Launch the application again from the
“SongPal” application.
While running the “SongPal” application
via BLUETOOTH, the display automatically
switches to [BT AUDIO].
q
The “SongPal” application or BLUETOOTH
function has failed.
q
Run the application again.
The “SongPal” application is automatically
disconnected when the display switches
to [IPD].
q
The “SongPal” application on iPhone/iPod
does not support iPod playback.
– Change the source of the unit to other
than [IPD], then establish the “SongPal”
connection (page 19).
Pandora® operation
Pandora® connection is not possible.
q
Shut down the Pandora® application on
the mobile device, and then launch it
again.
Messages
The following messages may appear or flash
during operation.
CD ERROR:
The disc cannot be played. The
disc will be ejected automatically.
q
Clean or insert the disc correctly, or make
sure the disc is not blank or defective.
CD NO MUSIC:
There is no playable file. The
disc will be ejected automatically.
q
Insert a disc containing playable files
(page 27).
CD PUSH EJT:
The disc could not be ejected
properly.
q
Press
ì
(eject).
HUB NO SUPRT:
USB hubs are not
supported.
INVALID
q
The selected operation could be invalid.
q
[USB MODE] cannot be changed during
iPod playback.
IPD STOP:
iPod playback has finished.
q
Operate your iPod/iPhone to start
playback.
NOT SUPPORT - ANDROID MODE
q
A USB device not supporting AOA
(Android Open Accessory) 2.0 is
connected to the unit while [USB MODE] is
set to [ANDROID].
– Set [USB MODE] to [MSC/MTP] (page 22).
OVERLOAD:
The USB device is overloaded.
q
Disconnect the USB device, then press SRC
to select another source.
q
The USB device has a fault, or an
unsupported device is connected.
READ:
Now reading information.
q
Wait until reading is complete and
playback starts automatically. This may
take some time depending on the file
organization.
USB ERROR:
The USB device cannot be
played.
q
Connect the USB device again.
010COV.book Page 33 Tuesday, August 30, 2016 3:16 PM
