11
GB
Op
er
ati
ons
Listening to the radio
1
Select “TUNER FM” or “TUNER
AM.”
Press TUNER/BAND (or
FUNCTION) repeatedly.
2
Perform tuning.
For automatic scanning
Press TUNING MODE repeatedly
until “AUTO” appears, and then press
+/– (or /– on the unit).
When a station is found, scanning
stops automatically, and “TUNED”
and “ST” (for stereo programs only)
light up on the display.
If “TUNED” does not light up and the
scanning does not stop, press
x
to stop
scanning, then perform manual tuning
(below).
When you tune to a station that
provides RDS services, the station
name appears on the display.
For manual tuning
Press TUNING MODE repeatedly
until “MANUAL” appears, and then
press +/– (or /– on the unit)
repeatedly to tune to the desired
station.
Tip
To reduce static noise on a weak FM stereo
station, press FM MODE repeatedly until
“MONO” appears to turn off stereo reception.
Use buttons on the remote to preset
stations.
1
Tune to the desired station.
2
Press TUNER MEMORY to select
the tuner memory mode.
3
Press +/– repeatedly to select
the desired preset number.
If another station is already assigned to
the selected preset number, the station
is replaced by the new station.
4
Press ENTER to store the
station.
5
Repeat steps 1 through 4 to
store other stations.
You can preset up to 20 FM and
10 AM stations. The preset stations are
retained for about half a day even if
you disconnect the power cord or if a
power failure occurs.
6
To bring up a preset radio
station, press TUNING MODE
repeatedly until “PRESET”
appears, and then press +/–
repeatedly to select the desired
preset number.
Presetting a radio station
Preset number
