9
GB
G
e
ttin
g
St
ar
ted
Insert the two supplied R6 (size AA)
batteries, matching the polarities shown
below.
Notes
• Do not mix an old battery with a new one or
mix different types of batteries.
• If you do not use the remote for a long period
of time, remove the batteries to avoid damage
from battery leakage and corrosion.
• Batteries installed devices shall not be
exposed to excessive heat such as sunshine,
fire or the like.
Remove a disc if inserted and turn off the
system, and then unplug the power cord.
Setting the clock
Use buttons on the remote to set the clock.
1
Press
?
/
1
to turn on the system.
2
Press CLOCK/TIMER SET.
If “PLAY SET” flashes, press
.
/
>
repeatedly to select “CLOCK,”
and then press ENTER.
3
Press
.
/
>
repeatedly to set
the hour, and then press ENTER.
4
Use the same procedure to set
the minutes.
Note
The clock settings are lost when you disconnect
the power cord or if a power failure occurs.
To display the clock when the
system is off
Press DISPLAY repeatedly until the clock
is displayed. The clock is displayed for
about 8 seconds.
Inserting batteries
When carrying this system
