38
GB
7
Press
"/1
to turn off the system.
The system turns on 15 seconds before
the preset time. If the system is on at
the preset time, the Play Timer and the
Recording Timer will not play or
record.
Other operations
Notes
• If you use the Play Timer or Recording Timer
and the Sleep Timer at the same time, the
Sleep Timer has priority.
• The Play Timer and Recording Timer will not
be activated if the system is turned on or if
“STANDBY” flashes in the display.
• The volume is reduced to minimum during
Recording Timer.
Changing the display
1
Press AMP MENU repeatedly to
select the item you want.
The last selected item setting appears
in the display.
SPECTRUM
Turn on or off the spectrum analyzer
display.
DIMMER
Adjust the brightness of the display.
2
Turn OPERATION DIAL to select
the setting you want.
3
Press ENTER.
— Power Saving Mode
The demonstration display and the clock
display can be turned off to minimize the
amount of power consumed during
standby mode (Power Saving Mode).
Press DISPLAY repeatedly while
the system is turned off.
Demonstration
1)
t
No display
(Power Saving Mode)
t
Clock
2)
t
Demonstration
t
…
1)
The display changes and the indicators flash
even when the system is turned off.
2)
The clock display automatically turns to
Power Saving Mode after 8 seconds.
Note
You cannot perform the following operations
during Power Saving Mode:
– Setting the clock (page 16).
– Changing the AM tuning interval (page 29).
– Turning on the system by pressing the
function buttons (CD, TUNER/BAND, TAPE
A/B, AUDIO, VIDEO or
).
– Changing the CD/USB power manage setting
To
Do this
Check the setting
1
Press CLOCK/TIMER
SELECT.
“SELECT” appears in
the display.
2
Press
.
or
>
repeatedly to select
“PLAY SELECT?” or
“REC SELECT?”, then
press ENTER.
Change the
setting
Start from step 1.
Cancel the Play
Timer or
Recording Timer
1
Press CLOCK/TIMER
SELECT.
“SELECT” appears in
the display.
2
Press
.
or
>
repeatedly to select
“TIMER OFF?”, then
press ENTER.
Turning off the display
USB
