20
GB
MHC-RG77 4-238-409-
13
(1)
Waking up to music
— Daily Timer
You can wake up to music at a preset time
every day. Make sure you have set the clock
(see “Setting the clock” on page 8).
1
Prepare the music source you want to
play.
• CD: Load a CD. To start from a specific
track, make a program (see “Programming
the CD tracks” on page 10).
• Tape: Load a tape with the side you want
to play facing forward.
• Radio: Tune in the preset station you
want (see “Listening to the radio” on page
11).
2
Adjust the volume.
3
Press CLOCK/TIMER SET on the
remote.
“DAILY1 SET” appears.
4
Press
V
or
v
repeatedly to select
“DAILY1 SET (or DAILY2 SET)”, then
press ENTER.
“ON” appears and the hour digits flash in
the display.
5
Set the time to start playback.
Press
V
or
v
repeatedly to set the hour,
then press ENTER.
The minute indication flashes.
Press
V
or
v
repeatedly on the remote to
set the minute, then press ENTER.
The hour indication flashes again.
6
Set the time to stop playback following
step 5 above.
7
Press
V
or
v
repeatedly until the music
source you want appears.
The indications change as follows:
t
TUNER
y
CD PLAY
T
t
TAPE PLAY
T
8
Press ENTER.
The type of timer (“DAILY1” or
“DAILY2”), followed by the start time, stop
time and the music source appears, then the
original display appears.
9
Turn off the power.
To
Check the setting
Change the setting
Cancel the timer
operation
Tip
The power turns on 15 seconds before the preset time.
Note
If the power is on at the preset time, the Daily Timer
does not work.
Do this
Press CLOCK/TIMER
SELECT on the remote and
press
V
or
v
repeatedly to
select the respective mode
(“DAILY1” or “DAILY2”),
then press ENTER.
Start from step 1.
Press CLOCK/TIMER
SELECT on the remote and
press
V
or
v
repeatedly to
select “TIMER OFF”, then
press ENTER.
