8
GB
Inserting two R6 (size AA)
batteries into the remote
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
Attaching the speaker pads
Attach the supplied front speaker pads to the
bottom of the speakers to stabilize the speakers
and prevent them from slipping.
1
Press
?/1
to turn on the system.
2
Press CLOCK/TIMER SET.
3
Press
M
or
m
repeatedly to set the hour.
4
Press
,
.
5
Press
M
or
m
repeatedly to set the
minute.
6
Press ENTER.
The clock starts working.
To adjust the clock
1
Press CLOCK/TIMER SET.
2
Press
M
or
m
to select “CLOCK SET”, then
press ENTER.
3
Do the same procedures as step 3 to 6
above.
Notes
• The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
• You cannot set the clock in Power Saving Mode.
When carrying this system
Perform the following procedure to protect
the CD mechanism.
1
Make sure that all discs are removed
from the system.
2
Hold down CD and then press
?/1
until
“STANDBY” appears.
After “STANDBY” disappears, then
“LOCK” appears.
3
Unplug the power cord.
Setting the clock
