52
Before placing a cassette in the
tape deck
Take up any slack in the tape. Otherwise the tape
may get entangled in the parts of the tape deck and
become damaged.
When using a tape longer than 90
minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding etc.
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use.
When the tape heads become dirty;
— the sound is distorted
— there is a decrease in sound level
— the sound drops out
— the tape does not erase completely
— the tape does not record
Make sure to clean the tape heads before you start
an important recording or after playing an old tape.
Use separately sold dry-type or wet-type cleaning
cassette. For details, refer to the instructions of the
cleaning cassette.
Demagnetizing the tape heads
Demagnetize the tape heads and the metal parts that
have contact with the tape every 20 to 30 hours of
use with a separately sold demagnetizing cassette.
For details, refer to the instructions of the
demagnetizing cassette.
In case color irregularity is
observed on nearby a TV screen.
With the magnetically shielded type of speaker
system, the speakers can be installed near a TV set.
However, color irregularity may still be observed on
the TV screen depending on the type of your TV set.
If color irregularity is observed…
Turn off the TV set once, then turn it on after 15 to
30 minutes.
If color irregularity is observed
again…
Place the speakers farther away from the TV set.
Troubleshooting
If you run into any problem using this unit,
use the following check list.
First, check that the power cord is connected
firmly and the speakers are connected
correctly and firmly.
Should any problem persist, consult your
nearest Sony dealer.
General
The display starts flashing as soon as you
plug in the power cord even though you
haven’t turned on the power
(demonstration mode).
•Press DEMO (STANDBY) when the
power is turned off.
The demonstration mode appears
automatically the first time you plug in the
power cord or if there is a power outage.
The clock setting is canceled.
•The power cord is disconnected or a
power failure occurs. Redo “Step 2:
Setting the time”. If you have set the
timer, also redo “Waking up to music”
and “Timer-recording radio programs”.
The radio presetting/timer setting is
canceled.
•The power cord is disconnected or a
power failure occurs for longer than half
a day. Redo “Step 3: Presetting radio
stations”.
There is no sound.
•Rotate VOLUME clockwise.
•The headphones are connected.
•Insert only the stripped portion of the
speaker cord into the SPEAKER jack.
Inserting the vinyl portion of the speaker
cord will obstruct the speaker
connections.
•The protective device on the amplifier
has been activated because of short
circuit. (“PROTECT” and “PUSH
POWER” flash alternately.) Turn off the
unit, eliminate the short-circuit problem
and turn on the power again.
•There is no audio output during timer
recording.
Precautions (continued)
Summary of Contents for MHC-VX3
Page 59: ...59 ...
