53
Tele-File System
Chapt
er
3
Re
c
o
rdin
g and Pl
a
y
b
a
c
k
3-4 Tele-File System
3-4-1 Recording the Recording Start
Time Code onto the Memory Label
The VTR section is compatible with the Tele-File memory
label system.
This system allows you to record the recording start time
code, model name, serial No. and TAPE format onto the
MLB-1M-100 memory label (not supplied). This is very
helpful for management of the cassette tapes and to
improve the efficiency of the tape editing.
The memory label attached to the cassette is automatically
detected.
Recording the recording start time code
onto the memory label
Follow the procedure below to record the recording start
time code.
1
Insert the cassette onto which the MLB-1M-100
memory label has been attached.
2
Press the VTR START button or the VTR button on the
lens.
At the instant the recording starts, the time code of the
recording start is recorded on the memory label.
Confirming the remaining capacity on the
memory label
1
Set the MENU ON/OFF switch to ON while pushing
the MENU knob.
The TOP menu appears.
2
Turn the MENU knob to move
b
mark to FILE.
3
Push the MENU knob.
When the FILE menu is first used, the CONTENTS
page of the FILE menu appears.
Or if you used the FILE menu already, the page that
was on the screen when the last FILE menu operation
ended appears on the viewfinder screen.
4
When the CONTENTS page is displayed, turn the
MENU knob to move
b
mark to TELE FILE, then
push the MENU knob.
When any page of the FILE menu is displayed, turn the
MENU knob until the TELE FILE page appears, then
push the MENU knob.
TELE FILE page
The remaining capacity of the memory label is
displayed at the REMAIN column.
You can record the recording start time code about 130
times on the memory label of 1 Kilobyte.
When the remaining capacity of the memory label
becomes 0%, you can not record the recording start time
code any more.
0% is displayed at the REMAIN column and the message
“MEMORY FULL” is displayed at the STATUS column.
Warnings on the viewfinder screen when the
remaining capacity is 0%
In the following cases, the message “TELE FILE
MEMORY FULL” is displayed at the setting change and
adjustment progress message display area of the
viewfinder.
• When loading the cassette onto which the memory label
whose memory capacity is 0% is attached.
• When loading the cassette onto which the memory label
whose memory capacity is 0% is attached and starting /
stopping the recording.
Memory label
Window outwards
Cassette holder
Insert the cassette
Push and close the lid.
Note
TELE FILE CLEAR : EXEC
TELE FILE MARK : OK
ID:
SIZE : 1KBYTE
REMAIN : 100%
STATUS : STANDBY
?F10 TELE FILE TOP
Summary of Contents for MSV-970
Page 5: ...5 ...
Page 168: ...168 Index Index ...
Page 170: ...Sony Corporation MSW 970 970P SY 3 863 920 03 1 Printed in Japan 2006 11 13 2005 ...
