masterpage:Left
filename[D:\WORKS\CD\3067952121\3067952121DirectCDUC\02GB-
DirectCDUC\03pre.fm]
10
model name1[MVC-CD200/CD300]
[3-067-952-12(1)]
Using DirectCD
You have to install the USB driver into your computer to connect the camera to your
computer with the USB cable.
For details on the installation of the USB driver and on the directory, refer to the
operating instructions of the camera.
Initialization described in the operating instructions of the camera or selecting
[Format] on the DirectCD screen is required for using a disc, however, these do not
have compatibility each other. And “format” described in the operating instructions
of the camera is to erase all the files in the CD-RW, and this is different from
[Format] on the DirectCD screen.
Do not connect your camera to your computer before
installing the USB driver.
Note
When you write new data onto the disc, before removing
the disc from the camera, be sure to follow the procedure
for removing the disc (page 12). If you remove the disc or
disconnect the USB cable, without following the
procedure, data on the disc may be broken.
Starting DirectCD
Do not initialize discs using DirectCD (this means that
selecting [Format] from the DirectCD screen). Be sure to
initialize discs using your camera.
1
After starting up your computer, insert a disc into the camera, and
connect to your computer with the USB cable.
to the USB connector
Computer
USB cable
to the USB jack
Push the connector
as far as it will go
01cov.book Page 10 Monday, July 23, 2001 2:09 PM
