1-11
MVS-8000X/7000X
1-5. Rack
Mounting
The MVS-8000X/MVS-7000X is mounted in the 19-inch
standard rack.
Precautions for Rack Mounting
w
.
To prevent the rack from falling or moving,
fi
x the rack
on a
fl
at and steady
fl
oor and the like using bolts or
others. If the rack falls due to the weight of the equip-
ment, it may cause death or serious injury.
.
Be sure to use the rack mount parts (supplied with MVS-
8000X). If not, injury may result and the equipment may
fall due to insuf
fi
cient strength.
.
After rack mounting, be sure to tighten the screws on the
rack angle and
fi
x the unit in the rack. If the screws on
the rack angle are not tightened, the unit may slip from
the rack and fall, causing injury.
w
When mounting the unit in the rack, note the following:
.
Be sure to mount in the rack with two persons or more.
.
Be careful not to catch your
fi
ngers or hands in the rack
mount rail or others.
.
Hold the bottom of unit and mount in the rack in a stable
position.
w
If several units are mounted in a rack, it is recommended to
install a ventilation fan to prevent temperature rise inside
the rack.
1-5-1. MVS-8000X
To mount the MVS-8000X in the rack, use the rack mount
parts (supplied with MVS-8000X) and follow the proce-
dure described below.
n
If other than the rack mount parts (supplied with MVS-
8000X) is used, the unit may not be mounted in the 19-inch
standard rack.
Using parts list (Accessory of the MVS-8000X)
.
Rack tool
2pcs
.
Support angle
2pcs
.
Bracket
4pcs
.
Rack tool attaching screw
(
+
B4
x
6 : 7-682-560-04)
6pcs
.
Support angle attaching screw
(
+
PSW4
x
10 : 7-682-962-01)
8pcs
.
Bracket attaching screw
(
+
B4
x
10 : 7-682-562-04)
8pcs
Other required parts
.
Screw for rack mounting
(
+
B5
x
12 : 7-682-576-09)
4pcs
Rack Mounting Procedure
1. Loosen the four screws (
+
B4
x
8) and remove the four
feet.
+B4
s
8
+B4
s
8
Feet
Feet
2. Remove the front panel of the equipment.
(Refer to Section 1-4-1.)
3. Attach the rack tool to the side of the equipment using
the speci
fi
ed six screws.
n
Use
+
B4
x
6 screws. Tighten the screws to the follow-
ing torque.
Tightening torque : 120
x
10
_
2
N
.
m {12.2 kgf
.
cm}
+B4
s
6
+B4
s
6
Rack tool
Rack tool
Summary of Contents for MVS-8000X System
Page 4: ......
Page 54: ......
Page 58: ...Sony Corporation MVS 7000X SY MVS 8000X SY E 4 189 509 03 Printed in Japan 2011 5 08 2010 ...
