28
H
X
REC
SYNC
L.SYNC
OVER
REP
1
TRACK (under)
DISC (under)
SHUF
MONO
TOC EDIT
When Off
Contents
Display
When Lit
During continuous playback (CLV: ON)
Tracking servo OFF
Recording mode ON
CLV low speed mode
ABCD adjustment completed
Tracking offset cancel ON
Tracking auto gain OK
Focus auto gain OK
Pit
High reflection
CLV-S
CLV LOCK
Jitter monitor
STOP (CLV: OFF)
Tracking servo ON
Recording mode OFF
CLV normal mode
Tracking offset cancel OFF
Groove
Low reflection
CLV-A
CLV UNLOCK
MEANINGS OF OTHER DISPLAYS
CD SECTION
Set the CD test mode when performing confirmations.
After completing confirmation, release the CD test mode.
1. AGING MODE
This mode repeatedly opens and closes the CD tray, and plays CD.
This operation is repeated unless an error occurs. If an error occurred, the aging stops.
Procedure:
(1)
Set a disc in advance.
(2)
Enter the test mode, then rotate
[ AMS ]
(CD) knob to display “0> AGING”, and press the
[ AMS ]
(CD).
(3)
When “AGING **” is displayed on the FL tube, rotate
[ AMS ]
(CD) knob so that ** portion becomes 00.
(4)
Press the
[ AMS ]
(CD), and the aging is executed through the following sequence.
Aging sequence
00: Normal
01: Exchange (not used)
02: Never mind
03: Never mind
04: BD access
05: Sound skip
06: Reverse to normal
(5)
To finish the aging, press the
x
(CD) button.
2. COMMAND TRANSFER MENU
Procedure:
(1)
Enter the test mode, then rotate
[ AMS ]
(CD) knob to display “1> COMMAND”, and press the
[ AMS ]
(CD)
knob.
(2)
Select a command with
[ AMS ]
(CD) knob, and press the
[ AMS ]
(CD) knob to set.
(3)
Select the edit position with
m
(CD) and
M
(CD) buttons, and rotate
[ AMS ]
(CD) knob for editing, then press the
[ AMS ]
(CD) knob for transfer.
(4)
To exit from this mode, press
x
(MD) button and
[ AMS ]
(MD) knob simultaneously.
3. C1, C2 ERROR DISPLAY
Procedure:
(1)
Enter the test mode, then rotate
[ AMS ]
(CD) knob to display “2> ERROR”, and press the
[ AMS ]
(CD) knob.
(2)
C1 error and C2 error are displayed on the left side and right side with 4-digit codes respectively.
(3)
To exit from this mode, press
x
(MD) button and
[ AMS ]
(MD) knob simultaneously.
4. DISC SPEED SELECTION
Procedure:
(1)
Enter the test mode, then rotate
[ AMS ]
(CD) knob to display “3> SPEEDx1”, and press the
[ AMS ]
(CD) knob.
(2)
Each time the
[ AMS ]
(CD) knob is pressed, the speed changes over such as x1
t
x2
t
x4
t
x1.
(3)
To exit from this mode, press
x
(MD) button and
[ AMS ]
(MD) knob simultaneously.
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L
l
L