16
MZ-E501
r
WAVEFORMS
Note on Schematic Diagram: MAIN SECTION
• All capacitors are in
µ
F unless otherwise noted. pF:
µµ
F
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
Note: The components identified by mark
0
or dotted
line with mark
0
are critical for safety.
Replace only with part number specified.
•
: B+ Line.
• Power voltage is dc 1.5V and fed with regulated dc power
supply from battery terminal.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark : PLAY
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: Audio (Analog)
J
: Audio (Digital)
*
Replacement of IC601 used in this set requires a special
tool.
•
The voltage and waveform of CSP (chip size package)
cannot be measured, because its lead layout is different
from that of conventional IC.
Note on Printed Wiring Boards: MAIN SECTION
•
X
: parts extracted from the component side.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen from the
(Side B)
pattern face are indicated.
Parts face side:
Parts on the parts face side seen from the
(Side A)
parts face are indicated.
• Main boards is four-layer pritnted board.
However, the patterns of layer 2 and 3 have not been
included in this diagrams.
*
Replacement of IC601 used in this set requires a special
tool.
•
Lead Layouts
Lead layout of
conventional IC
surface
CSP (chip size package)
SECTION 6
DIAGRAMS
1
2
3
4
Approx.
12 mVp-p
X601 (OSCO)
IC501
rs
(FE)
IC501
ed
(RF OUT)
IC501
1
TE
Approx.
1.2 Vp-p
Approx.
10 mVp-p
2.7 V
22.1 ns
Summary of Contents for MZ-E501
Page 36: ...36 MZ E501 MEMO ...