– 11 –
Note: In the Power mode, the power adjustment value is only
displayed.
4. During each test, press and hold down
> N
key or
.
key for a while to move the optical pickup on the sled outer or
inner perimeter.
5. To terminate the Manual mode and return to the TEST MODE,
press
x
key.
4-5. OVERALL ADJUSTMENT MODE
4-5-1. Outline of the function
This mode is designed to adjust the servo system automatically by
going through all the adjustment items.
Usually, this mode is used to perform automatic adjustments when
servicing the set.
For further information, refer to section 5. ELECTRICAL ADJUST-
MENTS (page 12).
4-4. MANUAL MODE
4-4-1. Outline of the function
The Manual mode is designed to perform adjustments and
operational checks on the set’s operation according to each
individual function.
Usually, no adjustments are made in this mode.
However, the Manual mode is used to clear the memory before
performing automatic adjustments in the Overall Adjustment mode.
4-4-2. How to set the Manual mode
1. Set the TEST MODE and press + key to set the Manual mode.
Remote control LCD display
3. During each test mode, the display is changed from one to
another each time DISPLAY key is pressed.
2. Each test item is assigned with a three-digit item number. The
third digit stands for a major item, the second digit for a middle
item, and the first digit for a moniro item.
000
AAASCC
Change Major
Item
Change Middle
Item
Change Minor
Item
Change Adjustment
Value
Write Adjustment
Value
.
key : Up
+
key : Down
key : Up
+
key : Down
key : Up
+
key : Down
key : Write
key
key
x
key
x
> N
key
> N
key : Up
key : Down
> N
X
011
XXXSXX
011
XX BXX
011
XX AXX
011
XXXJXX
011
XX RXX
731
XX VXX
Address Value & Adjustment Value
Block Error Value & Adjustment Value
ADIP Error Value & Adjustment Value
Jitter Value & Adjustment Value
Asy Mmetry Feed Back Gain Value & Adjustment Value
Power Adjustment Value
XXX: Each Value
XX: Adjustment Value
for Item number
Memory Monitor Mode
LCD display
LCD display
LCD display
LCD display
LCD display
LCD display
