– 6 –
1 0 0 V 1 . 0 0 0
ROM version display
SHUF
LCD on remote commander
SECTION 4
TEST MODE
Outline
• In this set, overall adjustment mode is made available by enter-
ing test mode to perform automatic adjustment of CD and MO.
In the overall adjustment mode, the disc is determined whether
it is CD or MO and adjustments are performed in sequence. If a
fault is found, the location of the fault is displayed. Also, in
servo mode, each adjustment can be automatically made.
• Operation in the test mode is performed with the remote com-
mander. A key having no particular description in the text, indi-
cates a remote commander key.
Setting the Test Mode
To enter the test mode, two methods are available :
1. Entering method with key input.
Turn on the HOLD switch on the set. While pressing the
p
key on the set, press the following remote commander keys in
the following order :
”
/
+
n
”
/
+
n
=
n
=
n
”
/
+
n
=
n
”
/
+
n
=
n
P
n
P
2. Entering method by shorting the test point
Solder bridge the test point TAP805 (TEST) on the MAIN
board (connect IC801 pin
#£
to GND), and turn on the power.
– MAIN BOARD (Conductor side) –
Releasing the Test Mode
A test mode releasing method varies depending on the test mode
setting method.
1. When test mode was entered with key input, turn off the power.
2. When test mode was entered by shorting the test point, turn
off the power and open the solder bridge of TAP805 (TEST
MODE) on the MAIN board.
Operation of Setting on Test Mode
When the test mode is set, the LCD displays the following :
• The cycle - the above ROM version display
n
All lit
n
All
off - is repeated.
• When the PLAYMODE key is pressed and hold down, the dis-
play at that time is held so that display can be checked.
Test mode
Short : Test mode
Open : Normal mode
(
)
”
/
+
key
”
/
+
key
p
key
p
key
p
key
p
key
VOL
+ key
VOL
– key
(044 Start?)
Overall
adjustment
mode (044 Auto?)
Adjustment
mode
(044 Manu?)
Servo mode
0 0 0
Audio mode
1 0 0
Power mode
3 0 0
VOL +/– keys
VOL
+/– keys
Display when test mode is set
VOL
+/– keys
Displays of the LCD on the remote commander
are shown in parenthesis.
Configuration of Test Mode
The test mode has the configuration given below.
Servo Mode
• Set the test mode, press the VOL – key and use the
”
/
+
key
to set the servo mode.
• When the servo mode is set, use the
+
/
”
key and the
=
key on the set to move the optical pick-up to the outer circum-
ference and to the inner circumference respectively.
• When entering another mode, refer to the configuration of test
mode.
1. Structure of Servo Mode
Servo mode
0 0 0
Offset adjustment
0 1 0
Laser power
adjustment
0 2 0
011
to
014
*
1
021
to
024
*
1
2
3
1
p
key
p
key
p
key
p
key
”
/
+
key
”
/
+
key
”
/
+
key
”
/
+
key
”
/
+
key
VOL
+/– keys
VOL
+/– keys
(See page 7.)
*
1 Repeatedly press
”
/
+
key
to change the mode.
(Refer to the following list
for a description of each
mode.)
Summary of Contents for MZ-E80
Page 12: ......
