17
MZ-N505
SOUND SKIP CHECK RESULT DISPLAY MODE
This set can display the count of errors that occurred during the
recording/playing for checking.
• Setting Method of Sound Skip Check Result Display
Mode
1. Set the test mode (see page 13).
2. Press the
N
key or
N
and
[T MARK/REC]
keys, and the
playing or recording sound skip result display mode becomes
active respectively where the LCD displays the following.
3. When the
N
key is pressed, total error count is displayed on
the LCD, and each time the
>
key is pressed, the display
item moves down by one as shown below. Also, if the
.
key
is pressed, the display item moves up by one, then if the
N
and
[T MARK/REC]
keys are pressed, the display in the
record mode appears.
When the
N
and
[T MARK/REC]
keys are pressed, total
error count is displayed on the LCD, and each time
the
>
key is pressed, the display item moves down by one
as shown below. Also, if the
.
key is pressed, the display
item moves up by one, then if the
N
key is pressed, the dis-
play in the play mode appears.
000
P * * R * *
000
E I B * *
000
S t a t * *
000
A d r s * *
000
B E m p * *
000
# # # # # #
000
P * * R * *
000
B O v r * *
000
B f u l * *
000
R t r y * *
000
# # # # # #
P**R**
: Total play/record errors (hex.)
**
: Counter of sound skip check each item (hex.)
######
: 6-digit address where sound was skipped last (hex.)
Playing sound skip
result display
Recording sound skip
result display
• Cause of Sound Skip Error
Cause of error
Description of error
EIB
Sound error correction error
Play
Stat
Decoder status error
Adrs
Address access error
BEmp
Buffer is empty
BOvr
Buffer is full, and sounds were
dumped
Record
Bful
Buffer capacity becomes less,
and forcible writing occurred
Rtry
Retry times over
4. To quit the sound skip check result display mode and to return
to the test mode (display check mode), press the
x
key.
• Setting Method of Key Check Mode
1. Set the test mode (see page 13).
2. Press the
[T MARK/REC]
and
X
keys on the remote commander
activates the key check mode. (At the last two digits, AD value of
remote commander key line is displayed in hexadecimal)
3. When each key on the set and on remote commander is pressed,
its name is displayed on the remote commander LCD. (The
operated position is displayed for 4 seconds after the slide
switch is operated. If any other key is pressed during this dis-
play, the remote commander LCD switches to its name dis-
play)
Example1: When the
>
key on the set is pressed:
Example2: When the
>
key on the remote commander is
pressed:
004
Remote commander LCD display
000
P**R**
Set LCD display
Total count of play
system errors (hex.)
Total count of record
system errors (hex.)
004
FF
Set LCD display
004
rPLAY
Set LCD display
Summary of Contents for MZ-N505 OpenMG Jukebox NOTES on installing & operating
Page 65: ...MZ N505 65 MEMO ...
