29
Troubleshooting and explanations
Troubles and solutions
If you find any troubles operating the recorder, follow the steps below.
1
Check this section, “Troubles and solutions” (page 29).
2
If you cannot solve the problem after you made checks, consult your nearest Sony
dealer.
While playing
Symptom
Cause/Remedy
An MD is not
played normally.
• Repeat play is selected.
,
Use MENU on the recorder to change back to the normal play
(page 18).
• Playback mode is changed.
,
Use MENU on the recorder to change back to the normal play
(page 18).
An MD is not
played from the
first track.
• Disc playing stopped before it came to the last track.
,
Press
NX
for 2 seconds or more to start playing.
• Group play mode is selected.
,
Use MENU on the recorder to change back to the normal play
(page 18), and then press
NX
for 2 seconds or more to start
playing.
The digital sound
preset function
does not work.
• The digital sound preset is off.
,
Select “SOUND1” or “SOUND2” (page 19).
Playback sound
skips.
• The recorder is placed where it receives continuous vibration.
,
Put the recorder on a stable place.
• A very short track may cause sound to skip.
,
Try not to create a track under one second long.
Sound has a lot of
static.
• Strong magnetism from a television or such device is interfering
with operation.
,
Move the recorder away from the source of strong magnetism.
Noise is
momentarily
heard.
• The sound was recorded in LP4 stereo mode.
,
Because of the nature of the compression method used in LP4
mode, noise may be output on very rare occasions during
playback of sound recorded in this mode.
Volume cannot be
turned up.
• AVLS is on.
,
Release AVLS settings (page 25).
Summary of Contents for MZ-NE410 Notes on installing & operating OpenMG
