30
While using group function
Others
No sound comes
through the
headphones/
earphones.
• The headphones/earphones plug is not firmly connected.
,
Plug in the plug of the headphones/earphones firmly to
i
.
• Volume is too low.
,
Adjust the volume by pressing VOL + or –.
• The plug is dirty.
,
Clean the plug.
The recorder skips
to several tracks
ahead or behind
when you press
.
or
>
.
• The GROUP button has been pressed (
is flashing in the
display).
,
The recorder returns to normal if no operation has made for 5
seconds.
The edited tracks
may exhibit sound
dropout during
search operations.
• This occurs due to the MiniDisc system limitation. The
fragmentation of data may cause sound dropout while searching
because the tracks are played in higher speed than normal
playback.
Symptom
Cause/Remedy
The group function
does not operate.
• While using a disc with no group setting, an attempt was made
to select some group-related menu (“No Gp” appears in the
display).
,
Use a disc with group setting.
A track cannot be
checked out to a new
group. A new group
cannot be created on
the supplied
SonicStage software.
• This is due to the MiniDisc system limitations. Group
information has been written to the area where the disc name is
stored. The disc name and track names are recorded in the same
area, which can store a maximum of approximately 1,700
characters. If the total number exceeds this amount, a new group
cannot be created even though group mode is on. It is also
impossible to make group settings at this time.
Symptom
Cause/Remedy
The recorder does
not work or works
poorly.
• The volume is low.
,
Turn up the volume.
• No disc is inserted (“NoDISC” appears in the display).
,
Insert a recorded disc.
Symptom
Cause/Remedy
Summary of Contents for MZ-NE410 Notes on installing & operating OpenMG
