– 57 –
– 58 –
– 60 –
– 59 –
MZ-R50
Note:
• All capacitors are in
µ
F unless otherwise noted. pF:
µµ
F
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
¢
: internal component.
•
A
: B+ Line.
•
C
: panel designation.
• Power voltage is dc 6V and fed with regulated dc power
supply from external power voltage jack (J901).
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark : PB
(
) : REC
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
5
6
r
WAVEFORMS
2.3Vp-p
12MHz
0.8Vp-p
32kHz
IC801
$º
VOLT/DIV : 1V AC
TIME/DIV : 20nsec
IC804
2
VOLT/DIV : 0.1V AC
TIME/DIV : 10
µ
sec
6-7. SCHEMATIC DIAGRAM – MAIN (3/3) SECTION –
r
Refer to page 64 for IC Block Diagrams.
Summary of Contents for MZ-R50 Analog PCLink
